4) You will need to have on hand garbage disposal tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
The repair of a ballcock tube is the simplest repair of all toilet leaks. There is a small black tube that is in the tank of the toilet that connects to the flush valve fill tube. If the tube slips from the little clasp that holds it in place, it can begin spraying water line repair in the tank and out from under the tank cover. To fix this toilet leak, simple re-attach the black tube to the clip. It really is that simple.
You don't want to be paying your plumber to clear the area before they start work particularly if you are paying an hourly rate. Empty cupboards and make sure there is nothing that may cost the plumber time and you money gaining access to the job.
Once you have disconnected the tank remove it from your work space. Do a thorough measurement of the remaining pipe for reference when you go to the hardware store. I will be honest with you, you might need to make a few trips back to the store. Once you get the new tank, slide it into place to line up the plumbing.
The first step in the replacement project is to turn off the water line repair to the toilet and flush any water that may be in the tank. If you forget this step, you will have a giant mess to clean up! You should now disconnect that water line.
When doing the install on a water heater, keep an eye out for unconnected pipes. A commonly missed pipe is the one that leads out from the area for drainage. It is probably a recirculation pipe; that helps your water remain heated without wasting too much water.
The plumber you hire does not normally do heating but will do hot water heating or in floor heating in the house. Some places you can use the water heater for both domestic hot water and for in floor heating if the heating is a secondary heat. Check with your local plumbing codes on this to be clear.